It Lives!
At another 3D printer club meeting, I picked up the sprockets I was missing previously, as well as a set of injection molded extruder drive gears. I assembled everything, and fired it up, and ran into a few problems… Continue reading
It Lives!
At another 3D printer club meeting, I picked up the sprockets I was missing previously, as well as a set of injection molded extruder drive gears. I assembled everything, and fired it up, and ran into a few problems… Continue reading
In my frequent prowls through secondhand shops, I stumbled on this positively gorgeous piece of pre-digital electronics — A Sony Digimatic Clock Radio
As I found it, it wasn’t working properly. The clock would run slow, and get stuck for hours at a certain time, before finally flipping around to the next minute. Something was wrong, so I plopped it on my bench and laid it bare to see if I could fix it… Continue reading